I have tested your program but it still doesnt work, when i used it prints out the 10 times the same serial number and it doesnt increase it.Īctually I need that this program runs only if it pass the test.everytime it pass the test the label will be printed. I would really appreciate if you could help me out or give me some other hint. I am not actually an expert on labview maybe I should use a loop depending on the times i ned to run the program or i am not sure, also tried to use the string to number add one and replace it and so on but none did what I am looking for. The printing is working fine but what it doesnt do the next time I run the program is to give me the next serial number, the first time i run the program should appear: 009208 and next print 009209 and so on. When I check your VI the only thing i see different is that you use %06d but where do you write the SN? The serial number cannot be fixed, it must be a counter:Īnother thing that I could do is to make the operator to type the SN but I think that would be too risky. The problem is that this will be used after the functional test and the label should be automatically printed with the S/N.
0 Comments
Leave a Reply. |